Advertising machine as the "fifth media" is now favored by all walks of life, but as a high load operating electronic equipment, the majority of customer friends are most concerned about the fear of their own advertising machine in the use process because of improper maintenance and problems, the following advertising machine factory for everyone to share the advertising machine maintenance We should pay attention to the problem to ensure the normal use of the outdoor highlighting advertising machine and extend the service life.

1: waterproof, moisture-proof and high temperature protection

Outdoor advertising machines should pay attention to waterproofing and moisture-proof, advertising opportunities to rain or damp, will lead to rust or oxidation affect circuit conditions. The indoor advertisement machine should pay special attention to the adjustment of indoor temperature. It is suggested that the heat dissipation space of more than 10cm should be left around the advertising machine, and the multimedia advertising machine equipment should not be placed in the sealed place, or the equipment is covered, the ventilation hole of the equipment is blocked, so that the temperature of the machine box is too high and damaged when the equipment works.

2 no frequency pullout power

Don't turn off the power by pluggable power. As the ad machine operates, the chip and the hard disk operate and read the information. If the power is removed immediately, it is easy to cause unrepairable damage to the hardware. If the blackout and other uncontrollable conditions lead to the forced shutdown of the advertising machine, it will also have to wait for 5 points. It is better to restart the clock above.

3: pay attention to the line of voltage

In the process of using the advertising machine, like other electronic devices, there is a rated power supply. If the voltage is unstable or exceeds the rated range of the power supply, it may cause the chip to burn down and stop working. It is suggested that the power supply should not be shared with the high-power equipment.

4 time cleaning

The necessity of cleaning the outdoor advertising machine is not to be said, but for the indoor advertising machine, although the indoor environment and the air is relatively good, it is inevitable that there will be dust and oil into the machine, so it also needs regular cleaning and maintenance. Before advertising, the machine must turn off the machine and unplug the power. When cleaning the dirt on the surface, it should be wiped with soft fabric and a little water. It is not suitable to use wet cloth with too much moisture to avoid water entering the screen and lead to short circuit. At the same time, try not to use corrosive cleaning agents or chemical reagents, so as not to corrode the paint or coating on the surface.